A Southwest jet and a small plane wound up on the same California runway after being cleared to land

WASHINGTON — A Southwest Airlines jet wound up on the same runway with a small private plane that had stopped after an air traffic controller cleared both planes to land on the same California runway in October, according to federal investigators.

The National Transportation Safety Board said Tuesday that the planes came within 900 feet (275 meters) t of each other before the smaller plane taxied off the runway.

The board said in a preliminary report that investigators interviewed the controller, a supervisor and others involved in the Oct. 19 incident in Long Beach, California. It did not comment on those interviews.

Related Articles

Crashes and Disasters |


Small plane crashes while landing on California street, 2 injured

Crashes and Disasters |


Haiti’s main airport shuts down after Spirit Airlines flight is hit by gunfire

Crashes and Disasters |


5 killed in California plane crash waited for battery to recharge before nighttime takeoff, report says

Crashes and Disasters |


Small plane lands on Highway 85 in Cupertino

Crashes and Disasters |


A California pilot killed in a plane crash at air show was an instructor for ‘Top Gun’ actors

The incident is among the latest in a number of recent cases in which planes came unnecessarily close due to errors by air traffic controllers or pilots.

The NTSB said a controller told the crew of a four-seat Diamond DA40 to land on the main runway and stop short of an intersecting runway. About two minutes later, the controller cleared pilots of the Southwest Boeing 737 to land on the main runway, followed shortly by the Diamond crew telling the controller that they were stopped on the runway, as directed.

As they were completing their landing rollout, the Southwest pilots told the controller that there was another aircraft on the main runway, the NTSB said. Both planes taxied to their parking areas without further incident.

You May Also Like

More From Author